TP-LINK TL-WR702N Specifications download pdf (Page 20)

TL-WR702N 150Mbps Wireless N Nano Router

- 14 -

Figure 3-6 Quick Setup - Wireless AP

¾ Wireless Radio - Enable or disable the wireless radio choosing from the pull-down list.

¾ SSID - Enter a string of up to 32 characters. The same name of SSID (Service Set

Identification) must be assigned to all wireless devices in your network. The default

SSID is set to be TP-LINK_XXXXXX (XXXXXX indicates the last unique six numbers of

each Router’s MAC address). But it is recommended strongly that you change your

networks name (SSID) to a different value. This value is case-sensitive. For example,

TEST is NOT the same as test.

¾ Region - Select your region from the pull-down list. This field specifies the region where

the wireless function of the Router can be used. It may be illegal to use the wireless

function of the Router in a region other than one of those specified in this field. If your

country or region is not listed, please contact your local government agency for

assistance.

¾ Channel - This field determines which operating frequency will be used. The default

channel is set to Auto. It is not necessary to change the wireless channel unless you

notice interference problems with another nearby access point.

¾ Mode - Select the desired mode. The default setting is 11/jointfilesconvert/223122/bgn mixed.

• 11b only - Select if all of your wireless clients are 802.11b.

• 11g only - Select if all of your wireless clients are 802.11g.

• 11n only- Select only if all of your wireless clients are 802.11n.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 174 175

No comments

TP-LINK TL-WR702N Specifications Page 20