TP-LINK TL-ER6120 User Manual download pdf (Page 92)

-87-

scenarios with lower requirement for identity protection.

Local ID Type:

Select the local ID type for IKE negotiation. IP Address: uses

an IP address as the ID in IKE negotiation. FQDN: uses a

name as the ID.

Local ID:

The local WAN IP will be inputted automatically if IP Address

type is selected. If Name type is selected, enter a name for

the local device as the ID in IKE negotiation

Remote ID Type:

Select the remote ID type for IKE negotiation. IP Address:

uses an IP address as the ID in IKE negotiation. FQDN: uses

a name as the ID.

Remote ID:

The remote gateway IP will be inputted automatically if IP

Address type is selected. If Name type is selected, enter the

name of the remote peer as the ID in IKE negotiation.

IKE Proposal:

Select the Proposal for IKE negotiation phase 1. Up to four

proposals can be selected.

Pre-shared Key:

Enter the Pre-shared Key for IKE authentication, and ensure

both the two peers use the same key. The key should consist

of visible characters without blank space.

SA Lifetime:

Specify ISAKMP SA Lifetime in IKE negotiation.

DPD:

Enable or disable DPD (Dead Peer Detect) function. If

enabled, the IKE endpoint can send a DPD request to the

peer to inspect whether the IKE peer is alive.

DPD Interval:

Enter the interval after which the DPD is triggered.

¾ List of IKE Policy

In this table, you can view the information of IKE Policies and edit them by the action buttons.

3.5.1.2 IKE Proposal

On this page, you can define and edit the IKE Proposal.

Choose the menu VPN→IKE→IKE Proposal to load the following page.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 168 169

No comments

TP-LINK TL-ER6120 User Manual Page 92