TP-LINK TL-R402M User Manual download pdf (Page 42)

TL-R402M Cable/DSL Router User Guide

1. Enter the following data:

¾ Destination IP Address - The Destination IP Address is the address of the network or

host that you want to assign to a static route

¾ Subnet Mask - The Subnet Mask determines which portion of an IP address is the network

portion, and which portion is the host portion

¾ Gateway - This is the IP address of the gateway device that allows for contact between the

router and the network or host

2. Click the Enable checkbox.

3. Repeat steps 1-2 until you are finished.

4. If you are finished. Click the Save button to save it.

To modify an existing entry:

1. Modify the entry’s Destination IP Address, Subnet Mask and Gateway.

2. Click the Save button.

To delete an existing entry:

1. Select the entry as you desire and make all of its fields blank.

2. Click the Save button.

To delete all the entries:

1. Click the Clear All button.

2. Click the Save button.

Note:

You can set up to 8 entries.

5.9 System Tools

- System Tools

y Firmware

y Factory Defaults

y Reboot

y Password

y Log

Figure 5-30 System Tools menu

There are five submenus under the System Tools menu (shown in

Figure 5-30): Firmware,

Factory Defaults, Reboot, Password and Log. Click any of them, and you will be able to

configure the corresponding function. The detailed explanations for each submenu are provided

below.

5.9.1 Firmware

The page (shown in Figure 5-31) allows you to upgrade to the latest version of firmware for the

router.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 55 56

No comments

TP-LINK TL-R402M User Manual Page 42