TP-LINK TL-MR3040 V2 User's Guide Page 212

  • Download
  • Add to my manuals
  • Print
  • Page
    / 241
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 211
TL-MR3040 Portable Battery Powered 3G/4G Wireless N Router
-201-
Figure 6-19 Wireless Advanced
¾
Beacon Interval - Specifies a value between 20-1000 milliseconds. The beacons are the
packets sent by the device to synchronize a wireless network. Beacon Interval value
determines the time interval of the beacons. The default value is 100.
¾ RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger
than the specified RTS Threshold size, the device will send RTS frames to a particular
receiving station and negotiate the sending of a data frame. The default value is 2346.
¾ Fragmentation Threshold - This value is the maximum size determining whether
packets will be fragmented. Setting the Fragmentation Threshold too low may result in
poor network performance since excessive packets. 2346 is the default setting and is
recommended.
¾ DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM).
You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
¾ Enable WMM - WMM function can guarantee the packets with high- priority messages
being transmitted preferentially. It is strongly recommended enabled.
¾ Enable Short GI - This function is recommended for it will increase the data capacity by
reducing the guard interval time.
¾ Enable AP Isolation - Isolates all connected wireless stations so that wireless stations
cannot access each other through WLAN. This function will be disabled if WDS/Bridge is
enabled.
6.6.5 Wireless Statistics
Selecting “Wireless > Wireless Statistics” will allow you to see the wireless transmission
information in the following screen shown in Figure 6-20.
Page view 211
1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 240 241

Comments to this Manuals

No comments