Tp-link 108M Wireless ADSL2+ Router TD-W8920G User Manual download pdf (Page 14)

TD-W8920G 108M Wireless ADSL2+ Router User Guide

Note:

If do not follow these guidelines, there may be significant performance degradation and you may

not be able to connect to the Router wirelessly.

3.6.2 Wired network connection

Wired network connections are provided through the Line port and LAN ports which are on the

back of the Router. See the Back Panel picture above and the illustrations below for examples.

3.6.2.1. Connect ADSL Line

Use the ADSL cable included with the Router to connect it to a telephone wall socket or

receptacle. Plug one end of the cable into the Line port (RJ11 receptacle) on the rear panel of the

Router and insert the other end into the RJ11 wall socket. If you are using a low pass filter device,

follow the instructions included with the device or given to you by your service provider. The ADSL

connection represents the WAN interface, the connection to the Internet. It is the physical link to

the service provider’s network backbone and ultimately to the Internet.

3.6.2.2. Hub or Switch to Router Connection

Connect the Router to an uplink port (MDI-II) on an Ethernet hub or switch with a straight-through

cable If you wish to reserve the uplink port on the switch or hub for another device, connect to

other MDI-X ports (1x, 2x, etc.) with a crossed cable.

3.6.2.3. Computer to Router Connection

You can connect the Router directly to a 10/100BASE-TX Ethernet adapter installed on a PC

using the Ethernet cable-10/100BASE-TX.

The illustration below shows the Router connected to Ethernet LAN devices, Wireless LAN

devices and the Internet. You can connect the Router directly to a 10/100BASE-TX Ethernet

adapter installed on a PC using the Ethernet cable provided as shown in this diagram.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 84 85

No comments

Tp-link 108M Wireless ADSL2+ Router TD-W8920G User Manual Page 14