12.3.3 Alarm Config
On this page, you can configure Statistic Group and Alarm Group for RMON.
Choose the menu SNMP→RMON→Alarm Config to load the following page.
Figure 12-11 Alarm Config
The following entries are displayed on this screen:
Alarm Table
Select: Select the desired entry for configuration.
Index: Displays the index number of the entry.
Variable: Select the alarm variables from the pull-down list.
Port: Select the port on which the Alarm entry acts.
Sample Type: Specify the sampling method for the selected variable and
comparing the value against the thresholds.
Absolute: Compares the values directly with the thresholds
at the end of the sampling interval.
Delta: Subtracts the last sampled value from the current
value. The difference in the values is compared to the
threshold.
Rising Threshold: Enter the rising counter value that triggers the Rising Threshold
alarm.
Rising Event: Select the index of the corresponding event which will be
triggered if the sampled value is larger than the Rising
Threshold.
Falling Threshold: Enter the falling counter value that triggers the Falling Threshold
alarm.
Falling Event: Select the index of the corresponding event which will be
triggered if the sampled value is lower than the Falling
Threshold.
Alarm Type: Specify the type of the alarm.
All: The alarm event will be triggered either the sampled
value exceeds the Rising Threshold or is under the Falling
Threshold.
149
Comments to this Manuals