TP-LINK 54Mbps User Manual download pdf (Page 9)

TL-WA501G 54M Wireless Access Point User Guide

2.3 Panel Layout

2.3.1 The Front Panel

Viewed from left to right, as shown in figure 2-1, the front panel of the TL-WA501G

consists of four LEDs, which is designed to indicate connections. Table 2-1 describes the

LEDs on the front panel of the AP.

Figure 2-1: Front Panel sketch

Name Action Description

Not lit No Power

POWER

Lit up Power on

Lit up The AP is initialising

Flashing The AP is working properly

SYSTEM

Not lit The AP has a hardware error

Not lit There is no device linked to the corresponding port

Lit up

There is a device linked to the corresponding port but no

activity

LAN

Flashing There is an active device linked to the corresponding port

Not lit The Wireless Radio function is disabled

WLAN

Flashing The Wireless Radio function is enabled

Table 2-1 The LEDs description

2.3.2 The Rear Panel

The rear panel contains the following features: (Viewed from left to right in figure 2-2)

¾ Wireless antenna

¾ Factory Default Reset button

¾ There are two ways to reset the AP's factory defaults:

1) Use the Factory Defaults function on System Tools -> Factory Defaults page

in the AP's Web-based Utility.

2) Use the Factory Default Reset button: First, turn off the AP's power. Second,

press and hold the default reset button then turn on the AP's power, until the

system LED lights up (about 3 seconds). Last, release the reset button and wait

for the AP to reboot.

Note: Ensure the AP is powered on before it restarts completely.

¾ One LAN 10/100Mbps RJ45 port for connecting the AP to hub or switch

¾ AC power socket: only use the power adapter supplied with the TL-WA501G

54Mbps Wireless Access Point, use of a different adapter may result in product

damage.

- 4 -

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 44 45

No comments

TP-LINK 54Mbps User Manual Page 9