TP-LINK TL-WA801ND V1 User's Guide download pdf (Page 35)

TL-WA801ND 300Mbps Wireless N Access Point User Guide

)

Note:

Limited by local law regulations, version for North America does not have region selection

option.

¾ Channel Width - Determines the channel width to be used. It is unnecessary to change the

default value unless required.

¾ Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations

to access the device.

Click the Search button to detect the SSIDs in the local area.

)

Note:

To apply any settings you have altered on the page, please click the Save button, and then you

will be reminded to reboot the device.

4) Repeater: This mode allows the AP with its own BSS to relay data to a root AP to which it is

associated with WDS enabled. The wireless repeater relays signal between its stations and

the root AP for greater wireless range.

Figure 4-11 Wireless Settings in Repeater mode

¾ MAC of AP - Enter the MAC address of the root AP of which you want to expand wireless

range.

¾ Region - Select your region from the pull-down list. This field specifies the region where the

wireless function of the device can be used. It may be illegal to use the wireless function of

the device in a region other than one of those specified in this field. If your country or region

is not listed, please contact your local government agency for assistance.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

No comments

TP-LINK TL-WA801ND V1 User's Guide Page 35