TP-LINK TL-WA801ND V1 User's Guide download pdf (Page 34)

TL-WA801ND 300Mbps Wireless N Access Point User Guide

3) Client: This mode allows the device to act as a wireless station to enable wired host(s) to

access an AP.

Figure 4-10 Wireless Settings in Client mode

¾ Enable WDS - The client can connect to AP with WDS enabled or disabled. If WDS is

enabled, all traffic from wired networks will be forwarded in the format of WDS frames

consisting of four address fields. If WDS is disabled, three address frames are used. If your

AP supports WDS well, please enable this option.

¾ SSID - If you select the radio button before SSID, the AP client will connect to the AP

according to SSID. Enter the SSID of AP that you want to access.

¾ MAC of AP - If you select the radio button before MAC of AP, the AP client will connect to

the AP according MAC address. Enter the MAC address of AP that you want to access.

¾ Region - Select your region from the pull-down list. This field specifies the region where the

wireless function of the device can be used. It may be illegal to use the wireless function of

the device in a region other than one of those specified in this field. If your country or region

is not listed, please contact your local government agency for assistance.

When you select your local region from the pull-down list, click the Save button, then the

Note Dialog appears. Click OK.

Note Dialog

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

No comments

TP-LINK TL-WA801ND V1 User's Guide Page 34