TP-LINK TL-WR940N V2 User's Guide download pdf (Page 30)

TL-WR940N/TL-WR941ND

300Mbps Wireless N Router

You can also keep the default WPS Status as Enabled and click the Add Device button

in Figure 4-2, then Choose “Press the button of the new device in two minutes” and

click Connect. (Shown in the following figure)

Figure 4-3 Add A New Device

Step 2: Press and hold the WPS button of the client device directly.

Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected

Setup process.

Step 4: When the WPS LED is on, the client device has successfully connected to the router.

Step 5: Refer back to your client device or its documentation for further instructions.

II. Enter the client device’s PIN on the router

Use this method if your client device has a Wi-Fi Protected Setup PIN number.

Step 1: Keep the default WPS Status as Enabled and click the Add Device button in Figure 4-2,

then the following screen will appear.

Figure 4-4 Add A New Device

Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then

click Connect button.

Step 3: “Connect successfully” will appear on the screen of Figure 4-4, which means the client

device has successfully connected to the router.

III. Enter the router’s PIN on your client device

Use this method if your client device asks for the router’s PIN number.

Step 1: On the client device, enter the PIN number listed on the router’s Wi-Fi Protected Setup

screen. (It is also labeled on the bottom of the router.)

-21-

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 111 112

No comments

TP-LINK TL-WR940N V2 User's Guide Page 30