TP-LINK TL-SL5428E V3 User's Guide Page 289
- Page / 303
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
6)
Select Use the following IP address. And the following items will be available. If the
switch's IP address is 192.168.0.1, specify IP address as 192.168.0.x (x is from 2 to
254), and the Subnet mask as 255.255.255.0.
2. In IPv6 network：
1) On the Windows taskbar, click the Start button, and then click Control Panel.
2) Click the View network status and tasks under the tab Network and Internet.
Figure B-4
3) Select Local Network Connection under the tab View your active networks on the
prompt page.
Figure B-5
4) In the prompt page that showed below, double click on the Internet Protocol Version 6
(TCP/IPv6).
279
- TL-SL5428E 1
- JetStream L2 Managed Switch 1
- COPYRIGHT & TRADEMARKS 2
- FCC STATEMENT 2
- CE Mark Warning 2
- Safety Information 3
- Package Contents 11
- Chapter 1 About This Guide 12
- Chapter 2 Introduction 17
- 2.3 Appearance Description 18
- 2.3.2 Rear Panel 19
- 3.1 Login 20
- Figure 3-3 Log in the switch 21
- 3.2 Configuration 22
- Chapter 4 System 24
- Figure 4-2 Port Information 25
- 4.1.2 Device Description 26
- 4.1.3 System Time 26
- 4.1.4 Daylight Saving Time 27
- 4.1.5 System IP 28
- IP Config 29
- 4.1.6 System IPv6 30
- Global unicast address 32
- Link-local Address Format 33
- Link-local Address Config 36
- 4.2 User Management 38
- Figure 4-12 User Config 39
- 4.3 System Tools 40
- 4.3.3 Firmware Upgrade 41
- 4.4 Access Security 42
- Figure 4-18 Access Control 43
- 4.4.2 SSL Config 44
- 4.4.3 SSH Config 45
- Figure 4-20 SSH Config 46
- Network Requirements 47
- Chapter 5 Switching 52
- 5.1.2 Port Mirror 53
- 5.1.3 Port Security 54
- Figure 5-3 Port Security 55
- 5.1.4 Port Isolation 56
- 5.1.5 Loopback Detection 56
- 5.2 LAG 58
- 5.2.1 LAG Table 59
- 5.2.2 Static LAG 60
- 5.2.3 LACP Config 61
- Figure 5-9 LACP Config 62
- 5.3 Traffic Monitor 63
- 5.3.2 Traffic Statistics 64
- 5.4 MAC Address 65
- 5.4.1 Address Table 66
- 5.4.2 Static Address 67
- 5.4.3 Dynamic Address 68
- Figure 5-14 Dynamic Address 69
- 5.4.4 Filtering Address 70
- Filtering Address Table 71
- Chapter 6 VLAN 72
- 6.1 802.1Q VLAN 73
- 6.1.1 VLAN Config 74
- 6.1.2 Port Config 76
- VLAN Port Config 77
- 6.2 MAC VLAN 78
- 6.2.1 MAC VLAN 79
- 6.3 Protocol VLAN 80
- 6.3.1 Protocol VLAN 81
- 6.3.2 Protocol Template 82
- 6.3.3 Port Enable 83
- 6.7 VLAN VPN 88
- 6.7.1 VPN Config 89
- 6.7.2 VLAN Mapping 89
- 6.7.3 Port Enable 90
- 6.8 Private VLAN 92
- Figure 6-15 93
- 6.8.1 PVLAN Config 95
- 6.8.2 Port Config 96
- 6.9 GVRP 98
- GVRP 99
- Figure 6-18 GVRP Config 100
- Configuration Procedure: 101
- Network Diagram 102
- Configuration Procedure 102
- Configure switch A 102
- Configure switch B 102
- Configure switch C 103
- Chapter 7 Spanning Tree 104
- Figure 7-1 Basic STP diagram 105
- Table 7-1 Comparing BPDUs 106
- 7.1 STP Config 108
- Figure 7-4 STP Config 109
- 7.1.2 STP Summary 110
- 7.2 Port Config 111
- 7.3 MSTP Instance 112
- 7.3.2 Instance Config 113
- 7.3.3 Instance Port Config 114
- Port Config 115
- 7.4 STP Security 116
- TC Protect 117
- BPDU Protect 117
- BPDU Filter 117
- 7.4.2 TC Protect 118
- Figure 7-11 TC Protect 119
- Configure switch A: 120
- Configure switch B: 120
- Configure switch C: 121
- Configure switch D: 121
- Chapter 8 Ethernet OAM 123
- OAM Functions 124
- Error 125
- 8.1 Basic Config 126
- 8.1.2 Discovery Info 127
- Local Client 128
- 8.2 Link Monitoring 130
- 8.3 RFI 131
- 8.4 Remote Loopback 132
- 8.5 Statistics 133
- 8.5.2 Event Log 134
- 8.6 DLDP 135
- Global Config 137
- Chapter 9 Multicast 141
- IPv4 Multicast Address 142
- IPv6 Multicast Address 142
- Multicast Address Table 144
- IGMP Snooping 144
- MLD Snooping 144
- 9.1 IGMP Snooping 145
- 9.1.1 Snooping Config 146
- 9.1.2 VLAN Config 147
- 9.1.3 Port Config 148
- 9.1.4 IP-Range 150
- 9.1.5 Multicast VLAN 151
- Configuration procedure: 152
- 9.1.6 Static Multicast IP 153
- 9.1.7 Packet Statistics 154
- 9.1.8 Querier Config 155
- Packet Statistics 156
- 9.2 MLD Snooping 157
- MLD Snooping Fundamentals 158
- MLD Snooping Process 158
- 9.2.1 Global Config 159
- 9.2.2 VLAN Config 160
- VLAN Config 161
- VLAN Table 161
- 9.2.3 Filter Config 162
- 9.2.4 Port Config 163
- 9.2.5 Static Multicast 163
- 9.2.6 Querier Config 164
- 9.2.7 Packet Statistics 165
- 9.3 Multicast Table 166
- 9.3.2 IPv6 Multicast Table 167
- Multicast IP Table 168
- Chapter 10 QoS 169
- Figure 10-2 802.1Q frame 170
- Figure 10-3 IP datagram 170
- Figure 10-4 SP-Mode 171
- Figure 10-5 WRR-Mode 171
- 10.1 DiffServ 172
- 10.1.2 DSCP Priority 173
- 10.1.3 802.1P/CoS Mapping 174
- 10.1.4 Schedule Mode 175
- 10.2 Bandwidth Control 176
- 10.2.2 Storm Control 177
- Figure 10-11 Storm Control 178
- 10.3 Voice VLAN 179
- 10.3.1 Global Config 181
- 10.3.2 Port Config 181
- Figure 10-13 Port Config 182
- 10.3.3 OUI Config 183
- Chapter 11 ACL 185
- 11.1.2 Time-Range Create 186
- 11.2 ACL Config 187
- 11.2.2 ACL Create 188
- 11.2.3 MAC ACL 188
- 11.2.4 Standard-IP ACL 189
- 11.2.5 Extend-IP ACL 190
- Create Extend-IP Rule 191
- Permit: Forward packets 191
- Deny: Discard Packets 191
- 11.3 Policy Config 192
- 11.3.2 Policy Create 193
- 11.3.3 Action Create 193
- 11.4 Policy Binding 194
- 11.4.2 Port Binding 195
- 11.4.3 VLAN Binding 195
- Chapter 12 Network Security 199
- 12.1.2 Manual Binding 200
- 12.1.3 ARP Scanning 201
- 12.1.4 DHCP Snooping 203
- DHCP Working Principle 204
- Option 82 205
- DHCP Cheating Attack 205
- Figure 12-8 DHCP Snooping 207
- 12.2 ARP Inspection 208
- Imitating Gateway 209
- Cheating Gateway 209
- Cheating Terminal Hosts 210
- Man-In-The-Middle Attack 211
- 12.2.1 ARP Detect 212
- 12.2.2 ARP Defend 213
- 12.2.3 ARP Statistics 214
- 12.3 IP Source Guard 215
- 12.4 DoS Defend 216
- 12.4.1 DoS Defend 218
- 12.5 802.1X 219
- 802.1X Timer 222
- 12.5.1 Global Config 223
- Figure 12-22 Global Config 224
- 12.5.2 Port Config 225
- 12.5.3 Radius Server 226
- 12.6 PPPoE Config 227
- Chapter 13 SNMP 230
- MIB Introduction 231
- 13.1 SNMP Config 232
- 13.1.2 SNMP View 233
- 13.1.3 SNMP Group 233
- Figure 13-5 SNMP Group 234
- 13.1.4 SNMP User 235
- User Table 236
- 13.1.5 SNMP Community 237
- 13.2 Notification 239
- 13.2.2 Traps Config 240
- Figure 13-9 Traps Config 241
- Port Traps 242
- 13.3 RMON 243
- 13.3.2 Event Config 244
- 13.3.3 Alarm Config 245
- Chapter 14 LLDP 247
- 14.1 Basic Config 250
- 14.1.2 Port Config 251
- 14.2 Device Info 252
- 14.2.2 Neighbor Info 253
- 14.3 Device Statistics 254
- Auto Refresh 255
- Global Statistics 255
- Neighbor Statistics 255
- Chapter 15 Cluster 257
- 15.1 NDP 258
- 15.1.2 NDP Summary 259
- 15.1.3 NDP Config 260
- Figure 15-4 NDP Config 261
- 15.2 NTDP 262
- 15.2.2 NTDP Summary 263
- 15.2.3 NTDP Config 264
- Figure 15-8 NTDP Config 265
- 15.3 Cluster 266
- Cluster Config 267
- Member Info 267
- 15.3.2 Cluster Config 268
- 15.3.3 Member Config 271
- 15.3.4 Cluster Topology 272
- Chapter 16 Maintenance 274
- 16.2 Log 275
- 16.2.1 Log Table 276
- 16.2.2 Local Log 277
- 16.2.3 Remote Log 277
- 16.2.4 Backup Log 278
- 16.3 Device Diagnostics 279
- 16.4 Network Diagnostics 280
- 16.4.2 Tracert 281
- 1. Hardware Installation 282
- Appendix A: Specifications 286
- Figure B-6 290
- 1.1 Installation Guide 292
- 1.2 Uninstall Software 295
- 1.3 Configuration 296
- 1.4 FAQ: 298
- Appendix D: Glossary 300
Related products and manuals for Network switches TP-LINK TL-SL5428E V3
Network switches TP-LINK TL-SL2428 User Manual
(140 pages)
(140 pages)
Network switches TP-LINK TL-SL5428E User Manual
(259 pages)
(259 pages)
Network switches TP-LINK TL-SG2210P User's Guide
(188 pages)
(188 pages)
© 2020, manymanuals.com. All rights reserved. | 0.074 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals