TP-LINK TL-SL5428E V3 User's Guide Page 139

  • Download
  • Add to my manuals
  • Print
  • Page
    / 303
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 138
2.
The unidirectional link should be disconnected once being detected, and the ports shut down
by DLDP can be restored after the fiber pairs are correctly connected.
Network Diagram
Figure 8-13 DLDP Application Example
Configuration Procedure
Step Operation Description
1 Enable DLDP globally. Required. On the Ethernet OAMDLDPDLDP page,
configure DLDP State as enable under the Global Config
tab in device A and B.
2 Enable DLDP on the
specified ports.
Required. On the Ethernet OAMDLDPDLDP page,
configure DLDP State as enable on Gigabit Ethernet ports
1/0/27 and 1/0/28 in the Port Config table in device A and
device B.
3 Configure Shut Mode. Required. On the Ethernet OAMDLDPDLDP page,
configure the Shut Mode as auto under the Global Config
tab in device A and B.
4 Check the ports’ state.
Required. On the Ethernet OAMDLDPDLDP page,
select ports 1/0/27 and 1/0/28 in the Port Config table and
click the Reset button to bring them up.
The DLDP information of Gigabit Ethernet ports 1/0/27 and 1/0/28 is shown below:
129
Page view 138
1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 302 303

Comments to this Manuals

No comments