TP-LINK TL-SG2424P User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 176
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
2.3 Appearance Description
2.3.1 Front Panel
Figure 2-1 Front Panel
The following parts are located on the front panel of the switch:
Reset: Press this button for 5 seconds or above to reset the software settings back to the
factory defaults.
10/100/1000Mbps RJ45 Ports: Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.
SFP Ports: Designed to install the SFP module.
Note:
When using the SFP port with a 100M module or a gigabit module, you need to configure its
corresponding Speed and Duplex mode on SwitchingPortPort Config page. For 100M
module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed
and Duplex mode of SFP port is 1000MFD.
LEDs
TL-SG2424P has a LED mode switch button which is for switching the LED status indication.
When the Speed LED is on, the port LED is indicating the data transmission rate. When the PoE
LED is on, the port LED is indicating the power supply status. By default the Speed LED is on.
Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then
the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again.
When the Speed LED is on, the port LED is indicating the data transmission rate.
LED Status Indication
On The switch is powered on.
Off The switch is powered off or power supply is abnormal.
Power
Flashing Power supply is abnormal.
Flashing The switch works properly.
System
On/Off The switch works improperly.
On
A 1000Mbps device is connected to the corresponding
port, but no activity.
Green
Flashing Data is being transmitted or received.
On
A 10/100Mbps device is connected to the
corresponding port, but no activity.
Yellow
Flashing Data is being transmitted or received.
10/100/1000Mbps
Port LED
Off No device is connected to the corresponding port.
6
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 175 176

Comments to this Manuals

No comments