TP-LINK TL-R600VPN Manual download pdf (Page 39)

6. How to configure a PPTP Server on TP-LINK Router

Suitable for: TL-ER6120, TL-ER6020, TL-ER604W

PPTP (Point to Point Tunneling Protocol) Server is used to create a VPN connection for

remote clients. To configure PPTP Server on TP-LINK router, please follow the instructions

below:

A. Make sure PCs of two sides can access to Internet

B. Configuring a PPTP Server on TP-LINK router

C. Configuring PPTP client on remote PC (Windows 7)

NOTE: If the TP-LINK Router is behind a NAT device, Virtual Server or DMZ should be

configured on the NAT device, otherwise the VPN tunnel can’t be established.

A. Make sure PCs of two sides can access to Internet

Before setup a VPN tunnel, you need to ensure that PCs of two sides are connected to the

Internet. After ensuring that there is an active Internet connection on each side, you need to

verify the VPN settings of the two sides, please follow the instruction below.

B. Configuring a PPTP Server on TP-LINK router

Step 1:

Access the router’s management webpage, verify the settings needed on the router.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 57 58

No comments

TP-LINK TL-R600VPN Manual Page 39