TP-LINK TL-ER5120 Installation Guide download pdf (Page 13)

Gigabit Load Balance Broadband Router

Requirements for the distance between Ethernet cable and other pipelines are shown

■

in the table.

Other Pipelines

Ethernet Cable

Min Parallel Net Length L

(mm)

Min Parallel-overlapping Net

Height H (mm)

Down-conductor 1000 300

PE 50 20

Service pipe 150 20

Compressed air pipe 150 20

Thermal pipe (not wrapped) 500 500

Thermal pipe (wrapped) 300 300

Gas pipe 300 20

The two diagrams below demonstrate parallel net length and parallel-overlapping net

height.

Note:

The above minimum net length/height is required when metal raceway is not

used. If any requirements cannot be met, you can add a steel tube or metal raceway

for shielding.

Requirements for the distance between Ethernet cable and high-power electric

■

devices are in following tables.

Cable Pave Way

Min Parallel

Length (mm)

<2kVA

powerline

Parallel cabling 130

One is in the grounded metal raceway or metal pipe 70

The both are in the grounded metal raceway or metal pipe 10

2~5kVA

powerline

Parallel cabling 300

One is in the grounded metal raceway or metal pipe 150

The both are in the grounded metal raceway or metal pipe 80

>5kVA

powerline

Parallel cabling 600

One is in the grounded metal raceway or meta

l pipe 300

The both are in the grounded metal raceway or metal pipe 150

Device Min Distance (m)

Switch case 1.00

Transformer room 2.00

Elevator tower 2.00

Air-conditioner room 2.00

Lightning Protection

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

TP-LINK TL-ER5120 Installation Guide Page 13

Comments to this Manuals

Related products and manuals for Routers TP-LINK TL-ER5120