Tp-link TL-WR941ND User Manual Page 42
- Page / 106
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
TL-WR941N/TL-WR941ND Wireless N Router
-35-
¾ Channel - This field determines which operating frequency will be used. The default channel
is set to Auto, so the AP will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
¾ Mode - Select the desired mode. The default setting is 11/jointfilesconvert/1313560/bgn mixed.
11b only - Select if all of your wireless clients are 802.11b.
11g only - Select if all of your wireless clients are 802.11g.
11n only- Select only if all of your wireless clients are 802.11n.
11/jointfilesconvert/1313560/bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.
11/jointfilesconvert/1313560/bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
Select the desired wireless mode. When 802.11g mode is selected, only 802.11g wireless
stations can connect to the Router. When 802.11n mode is selected, only 802.11n wireless
stations can connect to the AP. It is strongly recommended that you set the Mode to
802.11b&g&n, and all of 802.11b, 802.11g, and 802.11n wireless stations can connect to the
Router.
¾ Channel width - Select any channel width from the pull-down list. The default setting is
automatic, which can adjust the channel width for your clients automatically.
)
Note:
If 11b only, 11g only, or 11/jointfilesconvert/1313560/bg mixed is selected in the Mode field, the Channel Width
selecting field will turn grey and the value will become 20M, which is unable to be changed.
¾ Max Tx Rate - You can limit the maximum tx rate of the Router through this field.
¾ Enable Wireless Router Radio - The wireless radio of this Router can be enabled or
disabled to allow wireless stations access.
¾ Enable SSID Broadcast - When wireless clients survey the local area for wireless networks
to associate with, they will detect the SSID broadcast by the Router. If you select the Enable
SSID Broadcast checkbox, the Wireless Router will broadcast its name (SSID) on the air.
4.6.2 Wireless Security
Choose menu “Wireless→Wireless Security”, you can configure the security settings of your
wireless network.
There are five wireless security modes supported by the Router: WEP (Wired Equivalent Privacy),
WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi Protected Access 2), WPA2-PSK (Pre-Shared Key),
WPA-PSK (Pre-Shared Key).
- TL-WR941N 1
- TL-WR941ND 1
- Wireless N Router 1
- COPYRIGHT & TRADEMARKS 2
- FCC STATEMENT 2
- CE Mark Warning 3
- National restrictions 3
- DECLARATION OF CONFORMITY 4
- CONTENTS 5
- Package Contents 8
- Chapter 1. Introduction 9
- 1.3 Main Features 10
- 1.4 Panel Layout 11
- 1.4.2 The Rear Panel 12
- 2.1 System Requirements 13
- 2.3 Connecting the Router 13
- 3.1 TCP/IP Configuration 15
- Figure 3-4 Login Windows 17
- Figure 3-5 Quick Setup 18
- 4.1 Login 22
- 4.2 Status 22
- 4.3 Quick Setup 23
- 4.4 QSS 23
- Figure 4-2 QSS 24
- Figure 4-2 26
- ) Note: 28
- 4.5 Network 30
- Figure 4-6): 31
- Figure 4-8 WAN - PPPoE 33
- Figure 4-9 will then appear: 34
- In most cases 34
- Figure 4-10 35
- Figure 4-11 L2TP Settings 37
- Figure 4-12 PPTP Settings 38
- 4.6 Wireless 40
- 4.6.1 Wireless Settings 41
- 4.6.2 Wireless Security 42
- Figure 4-16 43
- Figure 4-17 43
- 4.6.4 Wireless Advanced 47
- 4.6.5 Wireless Statistics 49
- 4.7 DHCP 50
- 4.7.2 DHCP Clients List 51
- 4.7.3 Address Reservation 52
- 4.8 Forwarding 53
- Figure 4-31) 54
- 4.8.2 Port Triggering 55
- 4.8.3 DMZ 57
- 4.8.4 UPnP 58
- 4.9 Security 59
- Figure 4-37 Basic Security 60
- 4.9.2 Advanced Security 61
- 4.9.3 Local Management 62
- 4.9.4 Remote Management 63
- 4.10 Parental Control 64
- 4.11 Access Control 67
- 4.11.2 Host 70
- 4.11.3 Target 72
- 4.11.4 Schedule 74
- 4.12 Static Routing 75
- Figure 4-55 Static Routing 76
- 4.13 Bandwidth Control 77
- 4.14.1 Binding Setting 79
- 4.14.2 ARP List 80
- 4.15 Dynamic DNS 81
- 4.15.1 Comexe.cn DDNS 82
- 4.15.2 Dyndns.org DDNS 82
- 4.15.3 No-ip.com DDNS 83
- 4.16 System Tools 84
- 4.16.1 Time Setting 85
- 4.16.2 Diagnostic 86
- 4.16.3 Firmware Upgrade 87
- 4.16.4 Factory Defaults 88
- 4.16.5 Backup & Restore 88
- 4.16.6 Reboot 89
- 4.16.7 Password 90
- 4.16.8 System Log 90
- Figure 4-78 System Log 91
- 4.16.9 Statistics 93
- Appendix A: FAQ 95
- Figure A-3 MAC Clone 96
- Figure A-4 Virtual Servers 96
- Figure A-6 DMZ 97
- Figure A-9 Virtual Servers 99
- Figure B-1 100
- Figure B-2 101
- Figure B-3 102
- Figure B-4 103
- Appendix C: Specifications 104
- Appendix D: Glossary 105
Related products and manuals for Routers Tp-link TL-WR941ND
(85 pages)
Routers Tp-link TL-WA7510N V1 User Manual
(17 pages)
(17 pages)
Routers Tp-link TL-WR740N V4 User Manual
(121 pages)
(121 pages)
Routers Tp-link TD-W8961ND V3 User Manual
(102 pages)
(102 pages)
Routers Tp-link TD-W8961ND V2 User Manual
(103 pages)
(103 pages)
Routers Tp-link TL-MR3420 V2 User Manual
(119 pages)
(119 pages)
Routers Tp-link TL-R480T+ V4 User Manual
(7 pages)
(7 pages)
Routers Tp-link TD-8616 V7 User Manual
(18 pages)
(18 pages)
Routers Tp-link TL-WDR3600 V1 User Manual
(140 pages)
(140 pages)
Routers Tp-link TL-WR741ND V4 User Manual
(122 pages)
(122 pages)
Routers Tp-link TL-WR741ND V1 User Manual
(107 pages)
(107 pages)
Routers Tp-link TL-ER6120 V1 User Manual
(28 pages)
(28 pages)
Routers Tp-link TL-MR3220 V1 User Manual
(2 pages)
(2 pages)
Routers Tp-link TL-MR3020 V1 User Manual
(276 pages)
(276 pages)
Routers Tp-link TL-WA5110G V2 User Manual
(14 pages)
(14 pages)
Routers Tp-link TL-WDR4300 V1 User Manual
(139 pages)
(139 pages)
Routers Tp-link TL-R470T+ V2 User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 1.212 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals