1 Typical Network 1 Note The typical connection for TL-WA7510N is shown as above. Please make sure that the two CPEs are placed face to face;
10 The pigtail cable is used to change the N type port to RP-SMA type port. Login Appendix 1: External Antenna Installation
11 Click OK Configure the External Antenna A dialog box will prompt you for the User name and Password.Enter the default values and click OK.
12 Note T1. How do I restore my AP’s configuration to its factory default settings? T2. What can I do if I forget my password? 1) Restore
13 Click Change adapter settingsClick Properties Right-click Local Area Connection Double-click Internet Protocol Version 4 (TCP/IPv4)
14 ¾ For Windows XP OS Go to Start > Control Panel,you will then see the following page.Click Network and Internet Connections Select U
15 Double-click Internet Protocol (TCP/IP) Click Network Connections Click Properties Right-click Local Area Connection
16 Enter 192.168.1.100 into the IP address field, 255.255.255.0 into the Subnet mask field Click OK Select Use the following DNS server ad
Technical Support For more troubleshooting help, go to: www.tp-link.com/support/faq.asp To download the latest Firmware, Driver, Utility and U
2 Locate a suitable mounting site for your CPE. For choosing the best location, select an elevated location where trees, buildings and large s
3 The connection will be similar to the figure below after the above steps are finished. Turn on all your network devices and then check to see
4 Login A dialog box will prompt you for the User name and Password.Enter the default values and click OK. Note If the dialog box does no
5 Operation Mode Setting 2 A. Configuration for WISP Client (CPE) This page will then display. The AP supports three operation modes:
6 B. Configuration for Point-to-Point Connection 1) The AP Setting Click Finish to exit the Quick Setupwizard and wait until the AP compl
7 2) The Client Setting After your successful login, please configure the other TL-WA7510N by following the steps below. Click
8 C. Configuration for Repeater This page will then display. Select Repeater Click Search Click Wireless > Wireless Settings Find the BSSI
9 Antenna Alignment The BSSID is the same as the MAC address. Note After basic configuration of operationmode, you can adjust your CPE’s directi
Comments to this Manuals