TP-LINK TL-SG3424 V1 User's Guide Page 151
- Page / 290
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
141
The QoS module is mainly for traffic control and priority configuration, including three submenus:
DiffServ, Bandwidth Control and Voice VLAN.
9.1 DiffServ
This switch classifies the ingress packets, maps the packets to different priority queues and then
forwards the packets according to specified scheduling algorithms to implement QoS function.
This switch implements three priority modes basing on port, on 802.1P and on DSCP, and supports
four queue scheduling algorithms. The port priorities are labeled as CoS0, CoS1… CoS7.
The DiffServ function can be implemented on Port Priority, DSCP Priority, 802.1P/CoS
mapping and Schedule Mode pages.
9.1.1 Port Priority
On this page you can configure the port priority.
Choose the menu QoS →DiffServ →Port Priority to load the following page.
Figure 9-6 Port Priority Config
The following entries are displayed on this screen:
Port Priority Config
Select: Select the desired port to configure its priority. It is multi-optional.
Port: Displays the physical port number of the switch.
Priority: Specify the priority for the port.
LAG: Displays the LAG number which the port belongs to.
- JetStream L2 Managed Switch 1
- COPYRIGHT & TRADEMARKS 2
- FCC STATEMENT 2
- CE Mark Warning 2
- Safety Information 3
- Package Contents 11
- Chapter 1 About This Guide 12
- Chapter 2 Introduction 16
- 2.3 Appearance Description 17
- 2.3.2 Rear Panel 19
- 3.1 Login 21
- 3.2 Configuration 21
- Chapter 4 System 23
- Port Info 24
- 4.1.2 Device Description 25
- 4.1.3 System Time 25
- 4.1.4 Daylight Saving Time 26
- 4.1.5 System IP 28
- 4.1.6 System IPv6 29
- Link-local Address Config 36
- 4.2 User Management 38
- User Info 39
- User Table 39
- 4.3 System Tools 40
- 4.3.3 Firmware Upgrade 41
- 4.4 Access Security 42
- Access Control Config 43
- 4.4.2 SSL Config 44
- 4.4.3 SSH Config 45
- Key Download 47
- Network Requirements 47
- Chapter 5 Switching 52
- 5.1.2 Port Mirror 53
- Mirror Group List 54
- Mirror Group 55
- Mirroring Port 55
- Mirrored Port 55
- 5.1.3 Port Security 56
- Port Security 57
- 5.1.4 Port Isolation 58
- 5.1.5 Loopback Detection 59
- 5.2 LAG 60
- 5.2.1 LAG Table 61
- 5.2.2 Static LAG 62
- 5.2.3 LACP Config 63
- LACP Config 64
- 5.3 Traffic Monitor 65
- Traffic Summary 66
- 5.3.2 Traffic Statistics 67
- 5.4 MAC Address 68
- 5.4.1 Address Table 69
- 5.4.2 Static Address 70
- 5.4.3 Dynamic Address 71
- Aging Config 72
- 5.4.4 Filtering Address 73
- Create Filtering Address 74
- Filtering Address Table 74
- Chapter 6 VLAN 76
- 6.1 802.1Q VLAN 77
- PVID 78
- 6.1.1 VLAN Config 79
- VLAN Members 80
- 6.1.2 Port Config 81
- 6.2 MAC VLAN 83
- 6.3 Protocol VLAN 84
- Ethernet II 86
- 6.3.1 Protocol Group Table 87
- 6.3.2 Protocol Group 87
- 6.3.3 Protocol Template 88
- Configure Switch A 93
- Configure Switch B 93
- 6.7 GVRP 94
- GVRP 95
- Chapter 7 Spanning Tree 98
- STP Timers 99
- STP Generation 99
- In the beginning 99
- Comparing BPDUs 100
- Selecting the root bridge 100
- MSTP 102
- Port States 102
- Port Roles 102
- 7.1 STP Config 103
- Global Config 104
- Parameters Config 104
- 7.1.2 STP Summary 106
- 7.2 Port Config 107
- 7.3 MSTP Instance 108
- 7.3.2 Instance Config 109
- Instance Table 110
- 7.3.3 Instance Port Config 111
- Port Config 112
- 7.4 STP Security 113
- BPDU Filter 114
- Port Protect 114
- 7.4.2 TC Protect 115
- Network Diagram 116
- Configuration Procedure 116
- Configure Switch A: 116
- Configure Switch B: 116
- Configure Switch C: 117
- Configure Switch D: 118
- Return to CONTENTS 119
- Chapter 8 Multicast 120
- IPv4 Multicast Address 121
- IPv6 Multicast Address 121
- 8.1 IGMP Snooping 124
- 8.1.1 Snooping Config 126
- 8.1.2 VLAN Config 126
- VLAN Config 127
- VLAN Table 127
- 8.1.3 Port Config 128
- 8.1.4 IP-Range 129
- 8.1.5 Multicast VLAN 130
- Multicast VLAN 131
- Configuration procedure: 132
- 8.1.6 Static Multicast IP 133
- 8.1.7 Packet Statistics 134
- Auto Refresh 135
- IGMP Statistics 135
- 8.2 MLD Snooping 136
- 8.2.1 Global Config 137
- 8.2.2 VLAN Config 139
- 8.2.3 Filter Config 141
- 8.2.4 Port Config 142
- 8.2.5 Static Multicast 142
- 8.2.6 Querier Config 143
- 8.2.7 Packet Statistics 144
- Auto Fresh 145
- MLD Packet Statistics 145
- 8.3 Multicast Table 146
- 8.3.2 IPv6 Multicast Table 147
- Chapter 9 QoS 148
- Figure 9-2 802.1Q frame 149
- Figure 9-3 IP datagram 149
- Figure 9-4 SP-Mode 150
- Figure 9-5 WRR-Mode 150
- 9.1 DiffServ 151
- 9.1.2 DSCP Priority 152
- 9.1.3 802.1P/CoS mapping 153
- 9.1.4 Schedule Mode 154
- 9.2 Bandwidth Control 155
- 9.2.2 Storm Control 156
- Figure 9-11 Storm Control 157
- 9.3 Voice VLAN 158
- 9.3.1 Global Config 160
- 9.3.2 Port Config 160
- Figure 9-13 Port Config 161
- 9.3.3 OUI Config 162
- Chapter 10 PoE 164
- 10.1.1 PoE Config 165
- 10.1.2 PoE Profile 166
- 10.2 PoE Time-Range 167
- Time-Range Table 168
- Create Time-Range 168
- 10.2.3 PoE Holiday Config 169
- Chapter 11 ACL 171
- 11.1.2 Time-Range Create 172
- 11.2 ACL Config 173
- 11.2.1 ACL Summary 174
- 11.2.2 ACL Create 174
- 11.2.3 MAC ACL 175
- 11.2.4 Standard-IP ACL 176
- 11.2.5 Extend-IP ACL 176
- Create Extend-IP ACL 177
- 11.3 Policy Config 178
- 11.3.3 Action Create 179
- 11.4 Policy Binding 180
- 11.4.2 Port Binding 181
- 11.4.3 VLAN Binding 181
- Configuration Procedure: 182
- Chapter 12 Network Security 185
- Search Option 186
- Binding Table 186
- 12.1.2 Manual Binding 187
- 12.1.3 ARP Scanning 188
- 12.1.4 DHCP Snooping 189
- DHCP Working Principle 190
- Option 82 191
- DHCP Cheating Attack 192
- 12.2 ARP Inspection 195
- Cheating Terminal Hosts 196
- Man-In-The-Middle Attack 197
- ARP Flooding Attack 198
- 12.2.1 ARP Detect 199
- 12.2.2 ARP Defend 200
- 12.2.3 ARP Statistics 201
- 12.3 DoS Defend 202
- 12.4 802.1X 204
- 12.4.1 Global Config 208
- Authentication Config 209
- 12.4.2 Port Config 210
- 12.4.3 Radius Server 211
- Chapter 13 SNMP 214
- MIB Introduction 215
- 13.1 SNMP Config 216
- 13.1.2 SNMP View 217
- 13.1.3 SNMP Group 218
- 13.1.4 SNMP User 219
- HMAC-MD5 algorithm 220
- (Secure Hash Algorithm) 220
- 13.1.5 SNMP Community 221
- 13.2 Notification 223
- Create Notification 224
- 13.3 RMON 225
- 13.3.1 History Control 226
- 13.3.2 Event Config 226
- 13.3.3 Alarm Config 227
- Alarm Table 228
- Chapter 14 Cluster 230
- 14.1 NDP 231
- 14.1.2 NDP Summary 232
- Port Status 233
- 14.1.3 NDP Config 234
- 14.2 NTDP 235
- 14.2.2 NTDP Summary 236
- 14.2.3 NTDP Config 238
- 14.3 Cluster 239
- 14.3.2 Cluster Config 240
- Chapter 15 LLDP 245
- 15.1 Basic Config 249
- 15.1.2 Port Config 250
- 15.2 Device Info 251
- 15.3 Device Statistics 252
- Global Statistics 253
- 15.4 LLDP-MED 254
- 15.4.1 Global Config 255
- 15.4.2 Port Config 256
- 15.4.3 Local Info 257
- 15.4.4 Neighbor Info 258
- Neighbor Info 259
- Chapter 16 Maintenance 260
- 16.2 Log 261
- 16.2.1 Log Table 262
- 16.2.2 Local Log 263
- 16.2.3 Remote Log 263
- 16.2.4 Backup Log 264
- 16.3 Device Diagnostics 265
- 16.4 Network Diagnostics 266
- 16.4.2 Tracert 267
- Appendix A: Specifications 268
- 1. Hardware Installation 275
- 1. Installation Guide 279
- Figure D-6 Setup Status 281
- 2. Uninstall Software 282
- Figure D-9 Preparing Setup 283
- 3. Configuration 284
- 4. FAQ: 286
- Appendix E: Glossary 287
Related products and manuals for Network switches TP-LINK TL-SG3424 V1
Network switches TP-LINK TL-SL2428 User Manual
(140 pages)
(140 pages)
Network switches TP-LINK TL-SL5428E User Manual
(259 pages)
(259 pages)
Network switches TP-LINK TL-SG2210P User's Guide
(188 pages)
(188 pages)
© 2020, manymanuals.com. All rights reserved. | 0.058 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals