TP-LINK TD-W8960N Specifications download pdf (Page 23)

TD-W8960N Wireless N ADSL2+ Modem Router User Guide

This Advanced Setup section mainly introduces how to configure the Router for adequate use.

The detailed explanations for each subsection are provided below.

)

Note:

To completely configure the WAN Interface, you need to first select the Layer2 Interface (4.4.1

Layer2 Interface

) according to the connection ISP provides you, and then to select the type of the

connection (4.4.2 WAN Service) for the further configuration.

4.4.1 Layer2 Interface

Choose “Advanced Setup”Æ“Layer2 Interface”, and you can select WAN Service Interface

(layer2 interface) over ATM interfaces or ETH interface.

¾ ATM Interface: Configure the Router to access Internet as an ADSL user. ISP provides you

VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL Interface

with RJ11 connector. (Figure 2-1)

¾ ETH Interface: Configure the Router to access Internet as an Ethernet user. ISP provides

you Broadband Internet Service and the Ethernet Interface with RJ45 connector.

)

Note:

If the interface is used by the configuration of the 4.4.2

WAN Service, you need to remove the

corresponding WAN Service entry before you can remove it.

4.4.1.1 ATM interfaces

Choose “Advanced Setup”Æ“Layer2 InterfaceÆATM interface”, you can Configure ATM

interfaces on the screen below.

Figure 4-3

¾ Remove: Select the check box in the table on the screen above and then click the Remove

tab, the corresponding interface will be deleted in the table.

¾ Add: Click the button, and you can add a new interface in the next screen.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 104 105

No comments

TP-LINK TD-W8960N Specifications Page 23