TP-LINK Archer C20i User's Guide download pdf (Page 64)

Archer C20i AC750 Wireless Dual Band Router

- 53 -

Figure 4-34 Add A New Device

Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then

click Connect button.

Step 3: “Connect successfully” will appear on the screen of Figure 4-34, which means the client

device has successfully connected to the route

III. Enter the router’s PIN on your client device

Use this method if your client device asks for the router’s PIN number.

Step 1: On the client device, enter the PIN number listed on the router’s Wi-Fi Protected Setup

screen, shown in Figure 4-31.

Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup

process.

Step 3: When the WPS LED is on, the client device has successfully connected to the router.



Note:

1) The WPS LED on the router will light green for five minutes if the device has been

successfully added to the network.

2) The WPS function cannot be configured if the Wireless Function of the router is disabled.

Please make sure the Wireless Function is enabled before configuring the WPS.

4.7.3 Wireless Security

Choose menu “Wireless 5GHz → Wireless Security”, you can configure the security settings of

your wireless network.

There are five wireless security modes supported by the router: WPA-Personal, WPA2-Personal,

WPA-Enterprise, WPA2-Enterprise, and WEP.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 141 142

No comments

TP-LINK Archer C20i User's Guide Page 64