TP-LINK TP-PA2010P User Manual download pdf (Page 11)

TL-PA2010P AV200 Powerline Adapter with AC Pass Through

The Ethernet port is connected, but there is no data

being transferred.

Blinking The Ethernet port is transferring data.

Ethernet LED

Off The Ethernet port isn’t connected.

)

Note:

5 minutes after the device connected to the adapter is turned off, and the adapter will automatically

switch to the power-saving Mode. In power-saving mode, the Homeplug cannot be accessed via the

electrical wiring, but its integrated electrical socket can supply the power normally. As soon as the

device connected to the Homeplug is switched on again, your Homeplug will leave the power-saving

mode and the three LEDs will flash simultaneously.

2.3 Physical Interface

There are three physical interfaces on this Powerline Adapter.

Interface Description

Ethernet Port

A 10/100Mbps Ethernet port for connecting the adapter to the PC or the

broadband device with a network cable.

Power Plug

A Power Plug for connecting the adapter to a 100V ~ 240V AC power

socket.

Pair Button

Pair buttons are used to secure a powerline network. To secure your

network, please follow the steps below. Firstly, plug in a new adapter,

and press its pair button for 1 second; then plug in another adapter and

press its pair button for 1 second as well. The two buttons should be

pressed within 2 minutes of each other. After that, wait about 60 seconds

so that the two adapters can finish connecting.

Pair Button

Ethernet Port

Integrated

Electrical Socket

Power Plug

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

TP-LINK TP-PA2010P User Manual Page 11