TP-LINK TL-WR940N V1 Installation Guide download pdf (Page 5)

Internet Parameters Configuration

Configuration for PPPoE

Note

This page will then display.

fter completing the above configuration, please skip to Wireless Settings

Configuration.

Wait for the Router to detect the

connection type.

If PPPoE is detected, the screen will pop up as shown in A. Please proceed to AǗ

If Static IP is detected, the screen will pop up as shown in B. Please skip to BǗ

If Dynamic IP is detected, the screen will pop up as shown in C. Please skip to C.

1. Make sure the cable is securely plugged into the WAN port before

detection.

2. If the connection type your ISP provided is PPTP, L2TP or BigPond (o

Heart Beat Signal), you must go to “Network > WAN” to configure you

connection type manually.

Click Next

Select

Click Next

Enter the Username and

Password provided by your ISP

Click Next

1 2 3 4 5 6 7 8 9 10 ... 18 19

No comments

TP-LINK TL-WR940N V1 Installation Guide Page 5